5-4
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.3 Raising/Lowering the Tool
This function allows you to raise or lower the tool from the control panel.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
MARK TOOL U/D
BUFFER CLR. VIEW
(3) Press the [F3] key (TOOL U/D) to raise or lower the tool. Each time the [F3] key is pressed, the tool is alternately
raised and lowered.
(4) Press the
[PAUSE] key to cancel PAUSE mode.
While using this function, keep your hands out of the vicinity of the pen carriage.
To Next Page
Loading...
