GRAPHTEC FC2250 Series - Adjusting Cut;Plot Segment Lengths

5-13
Chapter 5 FUNCTION SETTINGS AND OPERATIONS
5.12 Setting the Distance Adjustment Values
This function is used to correct any discrepancies in the lengths of the cut or plotted line segments. If, for
example,theDISTANCEADJUSTsettingisspeciedas0.05%,andthedistanceofthecutis500mm,the
cutdistanceisincreasedby500x0.05%(=0.25mm),whichmeansthatthetotalcutdistanceis500.25mm.
(1) Press the [PAUSE] key to select PAUSE mode.
(2) Press the
[NEXT] key repeatedly until the following menu is displayed.
FORCE OFFSET
SPEED QUALITY
I/F FUNCTION
TOOL COND AREA OPT
(3) Press the [F3] key (FUNCTION) to display the menu shown below.
FORCE OFFSET
SPEED QUALITY
B.G. SETTINGS
DIST. ADJ SORTING
(4) Press the [F3] key (DIST ADJ.) to display the distance adjustment values setting screen.
FORCE OFFSET
SPEED QUALITY
DIST.ADJ
X= 0.00% Y= 0.00%
Press the [F2] key to move the blinking cursor to the X= parameter or the [F4] key to move the blinking cursor to the
Y= parameter, and then use the [ ] or [ ] key to change the respective numeric value.
Press the [ENTER] keytoconrmyourselections.
Setting range: -0.25 to +0.25(%), in 0.05(%) increments
(5) Press the
[PAUSE] key to cancel PAUSE mode.
These settings are retained in the plotter's internal memory even while the plotter is turned off.