Daily Maintenance and Storage
During daily maintenance, pay particular attention to the following points.
(1) Do not lubricate the plotter mechanisms.
(2) To clean the plotter's metal parts, either wipe the soiled areas with a dry cloth or with a cloth that has been
dampened with a neutral detergent diluted with water.
Do not use paint thinner, benzine, alcohol, or similar solvents as they may damage the casing's nish.
(3) If the writing panel surface is soiled, wipe it with a dry cloth. If the surface is extremely dirty, wipe the surface with
a cloth that has been dampened with alcohol or a neutral detergent diluted with water. Make sure that the cloth has
been well wrung out.
•
Do not use antistatic cleaners or cloths treated with an antistatic agent to clean an electrostatic writing panel.
Antistatic agents will adversely affect the electrostatic adhesion of the panel.
•
Do not use benzine, thinners, or similar solvents to clean the writing panel. They will damage the surface.
•
Electrostatic adhesion writing panels tend to attract airborne dust and dirt. Clean off any dust or dirt that
adheres to the writing panel.
•
During periods of high humidity, the adhesion force of electrostatic adhesion panels may drop slightly.
When the plotter is not in use, follow the instructions listed below.
(1) Remove the pen from the pen carriage and store it with the pen cap on.
(2) Cover the plotter with the soft cover supplied or a cloth to keep dust off.
(3) Store the plotter in a location which is not subject to either direct sunlight or high humidity.
To Next Page
Loading...
