GRAPHTEC FC4100 series - Background Settings for Gp-Gl; Command Control (:; Command)

Background Settings ♦
C5 - 3
LANGUAGE SELECTION
[ English ]
COMMAND ; AND :
ENABLED\\
DISABLED
“w” COMMAND
PEN UP\\
PEN DOWN
COMMAND ; AND :
ENABLED\\
DISABLED
Background Settings for GP-GL
LANGUAGE SELECTION
You may select one of the following 12 languages for the operation menu: Danish, Dutch, English,
French, German, Hungarian, Italian, Japanese, Norwegian, Portuguese, Spanish and Swedish.
Press the UP and DOWN ARROW keys to select the
desired language.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
“:” “;” Command Control (“:” “;” COMMAND)
When the GP-GL command mode is selected, set this function to enable or disable the
recognition of “:” and “;” commands set from the computer.
These commands may adversely affect the cutting results if the leading section of data is missing.
In such cases, set this function to DISABLED.
Press the F3 key to select ENABLED.
Press the F4 key to select DISABLED.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.