Setting the Interface Functions ♦ C7 - 5
STEP SIZE>
RS-232C>
COMMAND>
COMMAND
GP-GL\
HP-GL
COMMAND - Selecting the Command Mode
This function selects the command mode, either HP-GL™ or GP-GL.
NOTE: Be sure to set the command mode to match the command mode setting of your software
application
NOTE: Your command setting is retained in the plotter’s internal memory even while the plotter
is turned off.
Press the F4 key to select COMMAND.
Press the F3 key to select GP-GL command mode.
Press the F4 key to select HP-GL command mode.
Press the Enter key to register your setting.
If you started at the LOAD MEDIA menu you will return to the INTERFACE MENU.
If you started at the READY menu you will return to the MEDIA TYPE menu.
To Next Page
Loading...
