Preparing to Cut ♦
C3 - 26
CONDITION 2 14
30
READY 4
CB09Ux 0
TEST 1>
TEST 2>
CUTTING PRO>
CONDITION 2 14
30
READY 4
CB09Ux 0
TEST 1>
TEST 2>
CUTTING PRO>
Test 1
Use this TEST 1 pattern to test your condition settings.
With the media loaded in the plotter and the READY or PAUSE
mode displayed on the menu,
Press the TEST key on the Control Panel. You will
see the following test menu.
Press the F2 key to select TEST 1.
The plotter immediately cuts one (1) triangle from the current pen position.
n Adjust the cutting conditions and re-run the cutting test.
n Repeat this process until you achieve the desired results.
Press the ENTER key to return to the READY mode
when the results are satisfactory.
Test 2
If you feel you have almost achieved the best condition, use the TEST 2 pattern. This test cuts
three triangle patterns in 3 different cutting forces. The center triangle is cut using the force you
selected. The left triangle is cut using a force that is one step lower than your selection. The right
triangle is cut using a force that is one step higher than your selection. This allows you to confirm
that your force selection is the best.
With the media loaded in the plotter and the READY or PAUSE
mode displayed on the menu,
Press the TEST key on the Control Panel. You will
see the following test menu.
Press the F3 key to select TEST 2.
The plotter immediately cuts three (3) triangles from the current pen position.
n Adjust the cutting conditions and re-run the cutting test.
n Repeat this process until you achieve the desired results.
Press the ENTER key to return to the READY mode
when the results are satisfactory.
To Next Page
Loading...
