GRAPHTEC FC4100 series - To Change the Pen Speed C3; To Change the Pen Quality C3

Preparing to Cut ♦
C3 - 29
SET 12
CONDITION 1 30zz
4
PEN
SET 12
CONDITION 1 30
4zz
PEN
To Change the Pen Speed
Press the F2 key to change SPEED. A blinking cursor
indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 90 and +. [1 to 10, 15, 20,
25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, +.]
The “+” is 126cm/sec speed.
NOTE: The “+” selection is available with firmware version 1.13 or later.
Press the F1 key to change FORCE.
Press the F3 key to change QUALITY.
Press the ENTER key to register your setting.
To Change the Pen Quality
Press the F3 key to change QUALITY. A blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 8. The smaller the value,
the higher the quality.
Press the F1 key to change FORCE.
Press the F2 key to change SPEED.
Press the ENTER key to register your setting.