Advanced Functions and Settings ♦
C4 - 33
OPTION 1>
OPTION 2>
PEN UP SPEED>
OFFSET ANGLE>
OFFSET FORCE>
STEP PASS>
OFFSET ANGLE
ANGLE = 30
OFFSET ANGLE - Adjusting the Blade Offset Angle
Use this function to smooth curves on large characters or shapes. At the joints of each line
segment, the plotter stops cutting and very quickly rotates the blade tip. This ensures the
accurate cutting of the computer data. In some cases, it is better to bypass this blade rotation and
drag the blade in order to make the shape smoother and to shorten overall cutting time. This
action will result in a slightly different shape from the original computer data.
With this OFFSET ANGLE function, you may set the reference angle of connection, and eliminate
the blade control at the connections whose angles are under that reference angle.
Press the MENU key to select MENU mode.
Press the NEXT key.
Press the NEXT key again.
Press the NEXT key again.
Press the F3 key to select OPTION 1.
Press the F2 key to select OFFSET ANGLE.
Press the UP or DOWN ARROW key to sequence
through the available choices.
The OFFSET ANGLE can be set in a 61-step range
from 0 to 60.
Press the ENTER key to register your settings.
Press the MENU key to cancel MENU mode.
NOTE: Your OFFSET ANGLE setting is retained in the plotter’s internal memory even when
the plotter is turned off.
NOTE: Excessive settings may deform the shape of characters. Be sure to perform adequate
testing before performing your final cut to ensure that you have located the appropriate
setting which offers the proper quality.
To Next Page
Loading...
