GRAPHTEC FC4100 series - Chapter 2: Cutters and Holders; Cutter Types and Applications

Cutters and Holders ♦ C2 -
1
Chapter 2 Cutters and Holders
This chapter describes the different cutters and their uses.
Blade part no.
and type
Diameter
and blade
offset value
Plunger part
no.
Applications and features
CB09UA
(supersteel)
φ 0.9 mm
0.45
PHP32-CB09N
or
PHP32-CB09
Standard blade for cutting color
adhesive media. Suitable for cutting
media up to 0.25 mm thick.
Maximum cutting distance of
approximately 4000 m.
CB15U
(supersteel)
φ 1.5 mm
0.75
PHP32-CB15N
or
PHP32-CB15
For cutting media which is too thick for
the CB09UA blade to handle.
Suitable for cutting media from 0.25 mm
to 0.5 mm thick.
CB15U-K30
(supersteel)
φ 1.5 mm
0.75
PHP32-CB15N
or
PHP32-CB15
For cutting sandblast rubber. The
sharply angled point provides a longer
cutting edge. Suitable for cutting
material from 0.05 mm to 1.5 mm thick.
CB15-10C
(ceramic)
φ 1.5 mm
0.50
PHP31-CB15 This is the hardest blade, but may chip
or shatter if dropped or subjected to
impact. Suitable for cutting material up
to 0.05 mm thick.
CB15-05S
(sapphire)
φ 1.5 mm
0.25
PHP31-CB15 For cutting masking media.
Suitable for cutting material up to 0.05
mm thick.