Options ♦ C9 - 7
FC4100 Basket Option
The FC4100 Basket is used to keep your media clean during long length cuts.
The Basket is option in the FC4100-75, FC4100-100 and FC4100-130.
WARNING: Use two people to pick up the plotter.
CAUTION: Remove the plotter from the stand before assembling the basket onto the stand.
CAUTION: Do not install the plotter onto the stand with the conveyor rollers or media installed.
The unit becomes unstable when heavy loads are added. In extreme cases, the unit
may tip over.
CAUTION: Improper assembly of these pieces may cause the unit to become unstable when
heavy loads are added. In extreme cases, the unit may tip over.
CAUTION: The longer length leg platform is installed towards the back of the unit.
NOTE: The basket was designed to be used with Graphtec recommended media only. Other
media may be stiffer and will not flow into the basket smoothly.
NOTE: Always keep the wheels in a locked position when operating your plotter.
Contents
1. Four M6 x 16mm Socket Cap Screws
2. Four Hole Plugs
3. Cloth Basket
4. Two Basket Tubes
5. Two Tube Brackets
6. Eight Bushings with an Inner Diameter of .625” (If included)
7. Two Basket Brackets
8. Four Tube Stops
9. M6 Hex Key
To Next Page
Loading...
