Options ♦ C9 - 8
Basket Assembly
The following information will give you step by step instructions on how to assemble the Basket
Assembly for the GRAPHTEC FC4100 Cutting Plotter. For the best results, please follow all
instructions carefully.
Assembly Area: Assemble the Basket on a secure, flat surface.
Tools: M6 Hex Key
Mallet or Rubber Hammer
1. Attach Tube Bracket to the upper two
holes in the left side of the stand with two
M6 x 16mm Socket Cap Screws.
2. Attach Tube Bracket to the upper two
holes in the right side of the stand with
two M6 x 16mm Socket Cap Screws.
3. Insert eight .625 Diameter Bushings into
the front and rear holes of the Tube
Bracket.
(Step 3 in necessary only on those units
where the bushing are included in the
Basket Option.)
To Next Page
Loading...
