GRAPHTEC FC4100 series - Cutting Pro C3

Preparing to Cut ♦
C3 - 27
TEST 1>
TEST 2>
CUTTING PRO>
CONDITION 2 14
30
READY 4
CB09Ux 0
PATTERN CUTTING PRO
OK ?
YES>
NO>
Cutting Pro
Use the CUTTING PRO Test pattern to check your cutting quality with an actual cut pattern
without having to access your application software.
With the media loaded in the plotter and the READY or PAUSE
mode displayed on the menu,
Press the TEST key on the Control Panel. You will
see the following test menu.
Press the F4 key to select CUTTING PRO.
Press the F3 key to select YES and start.
Press the F4 key to select NO and cancel.
n Adjust the cutting conditions and re-run the cutting test.
n Repeat this process until you achieve the desired results.
Press the ENTER key to return to the READY mode
when the results are satisfactory.