GRAPHTEC FC4100 series - Withdrawal of the Pen Carriage C3; Returning the Pen Carriage to Origin C3

Preparing to Cut ♦
C3 - 34
Withdrawal of the Pen Carriage
This function moves the pen carriage from its current position to a position that is +100 mm away
along both the X and Y axes. This also helps to confirm the job is completed.
While holding down the ENTER key, press the UP ARROW key.
Repeat this process as needed to move the pen carriage away from the cutting/plotting job.
Returning the Pen Carriage to Origin
This function moves the pen carriage from its current position to the origin point.
While holding down the ENTER key and press the DOWN ARROW key.
The pen carriage will return to the origin point.