GRAPHTEC FC4100 series - Interface Function Settings

Setting the Interface Functions ♦ C7 - 2
LOAD MEDIA!
INITIAL MENU>
STEP SIZE>
RS-232C>
COMMAND>
AUTO PRE FEED>
INITIAL FEED SPEED>
INTERFACE>
CONDITION 2 14
30
READY 4
CB09Ux 0
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
STEP SIZE>
RS-232C>
COMMAND>
INTERFACE - Setting the Interface Functions
The Interface Functions (Step Size, RS-232C and COMMAND Settings) can be set before or after
loading media.
How to get to the INTERFACE menu before you have loaded media
When the media set lever is lowered, the following menu appears.
Press the F4 key to select INITIAL MENU.
Press F3 key to select RS-232C and the INTERFACE
menu appears.
Press the NEXT key twice to go back to the LOAD
MEDIA menu.
How to get to the INTERFACE menu after you have loaded media
After the media is loaded and initialization is performed, the plotter
goes to READY mode.
Press the MENU key to select MENU mode.
Press the NEXT key.
Press the NEXT key again.
Press F1 key to select INTERFACE.
Press F3 key to select RS-232C and the INTERFACE
menu appears.
Press the MENU key to return to READY mode.