Test Modes and Troubleshooting ♦
C6 - 18
Command Error Messages and Their Causes
Error Messages in GP-GL Command Mode
ERROR 1
COMMAND ERROR
ERROR 4
PARAMETER OVERFLOW
Cause Solution
The plotter received an
unrecognizable command.
• Noise was input to the
plotter upon execution
of the software
application
⇒ Press the ENTER key
• The software
configuration regarding
the output device has
been changed
⇒ Configure the software
to drive your plotter.
Ensure that the
software’s interface
conditions are correctly
set.
• The plotter’s interface
conditions have been
changed.
⇒ Ensure that the plotter’s
interface conditions are
set to match those of
the software.
Cause Solution
A command was received
containing numeric
parameter that exceeds that
command’s permissible
range.
• The software
configuration regarding
the output device has
been changed
⇒ Configure the software
to drive your plotter.
Ensure that the
software’s interface
conditions are correctly
set.
• The plotter’s interface
conditions have been
changed
⇒ Ensure that the plotter’s
interface conditions are
set to match those of
the software.
To Next Page
Loading...
