Preparing to Cut ♦
C3 - 33
AUTO PRE FEED>
INITIAL FEED SPEED>
INTERFACE>
INITIAL FEED SPEED
NORMAL\\
SLOW
AUTO PRE FEED>
INITIAL FEED SPEED>
INTERFACE>
ROLL-1>
ROLL-2>
SHEET>
CONTINUE>
Changing Feed Speed
This function allows you to change the media feed speed from SLOW to NORMAL. In the case of
selecting ROLL-1 and SHEET on the media type menu, the plotter uses SLOW to ensure the
accuracy of the leading and trailing edges of the media. After the initialization, the feed speed can
increase once the grit rollers and the pinch rollers secure the media. Always select SLOW for
heavy media or media with a slippery surface otherwise select NORMAL to shorten the
initialization time. Remember that the media will back up at the PEN UP SPEED when NORMAL
is selected. For details see FEED – Advancing Media.
When the media set lever is lowered, the following menu appears on the display.
Press the F4 key.
Press the F3 key to select INITIAL FEED SPEED.
Press the F3 key to select NORMAL.
Press the F4 key to select SLOW.
Press the ENTER key to return to the previous menu.
Press the NEXT key to return to the previous menu.
Press the F4 key to set such parameters as STEP
SIZE, RS232C CONDITIONS AND COMMANDS.
For details see Setting the Interface Conditions.
Raise the media set lever to engage the media.
The media type menu appears on the display, press key which
corresponds to the type of media that is loaded for
cutting/plotting.
Press the F1 key to select ROLL-1.
Press the F2 key to select ROLL-2.
Press the F3 key to select SHEET.
Press the F4 key to select CONTINUE.
LOAD MEDIA!
INITIAL MENU>
To Next Page
Loading...
