Test Modes and Troubleshooting ♦
C6 - 2
PRINT CONDITIONS
MOUNT THE PEN!
DONE>
CANCEL CONDITIONS>
CONDITION LIST>
SELF TEST>
DATA DUMP>
Press the F2 key to select CONDITION LIST.
The following message appears.
Confirm the pen is mounted on the carriage.
Press the F3 key to select DONE and start plotting.
Press the F4 key to select CANCEL CONDITIONS.
You have to turn off the plotter to cancel CONDITION, if the plotter is in CONDITION mode.
The following message appears and the plotter begins printing a
list of the currently set cutting conditions.
When all of the data has been printed, turn off the plotter to cancel CONDITION mode.
Sample printout of the CONDITION function
COND FORCE SPEED PEN TYPE OFST ACCL TNGNT OVCUT
\ 1 12 30 PEN 0 4 OFF
2 14 30 CB09Ux 0 4 OFF
3 17 30 OTHER +17 4 ON 0.2 0.2
4 25 10 CB15Ux 0 1 OFF
RS-232C BAUD RATE PARITY DATA BIT HANDSHAKE
\ 1 9600 N 8 H
2 9600 E 7 H
3 9600 E 8 H
COMMAND GP-GL STEP SIZE 0.100
HP-GL ORIGIN L.L. PAGE LENGTH 2000
PEN UP SPEED AUTO STEP PASS 0
OFFSET FORCE 4 OFFSET ANGLE 30
ROTATE OFF MIRROR OFF
DISTANCE ADJ 0 0
DISPLAY UNIT Mm COPY SPACE 1
AXIS TOOL LIGHT POINT AXIS METHOD 2POINT
AUTO PRE FEED DISABLED PRE FEED LENG 1
TANGENTIAL MODE MODE 1 FEED SPEED NORMAL
EXPAND LENG O SORT DISABLED
; , : COMMAND ENABLED MODEL EMULATED 7550
W COMMAND PEN DOWN PEN UP MOVE ENABLED
COND. PRIORITY MANUAL MEDIA SIZE SENSOR OFF
INIT. BLADE CTRL 2mm BELOW PIONCH ROLLER
SENSOR
OFF
DISPLAY LANG Japanese HL CIR RESOL DEFAULT
ROM VERSION 1.00
To Next Page
Loading...
