Out of the Box ♦ C1 -
5
Connecting the Plotter
Connecting to the Computer
The FC4100 Plotter is equipped with an RS-232 or Serial Interface Cable in the Accessory Kit.
1. Connect the 25 pin connector to the RS232-C connector
on the plotter and tighten the screws. If you are using a
Centronics compatible parallel interface cable connect
the 36 pin connector to the Parallel connector on the
plotter and lock the levers.
2. Connect the 9 pin connector to the connector on the
computer COM port and tighten the screws. If your
computer has a 25 pin connector port, use the 9 pin to
25 pin adapter that is supplied in the accessory kit.
Serial Connector
or Parallel Connector
To Next Page
Loading...
