GRAPHTEC FC4100 series - Pen Up;Down for the W Command

Background Settings ♦
C5 - 4
CONDITION PRIORITY
MANUAL\\
PROGRAM
“w” COMMAND
PEN UP\\
PEN DOWN
CONDITION PRIORITY
MANUAL\\
PROGRAM
INITIAL BLADE
CONTROL POSITION
2mm BELOW\\
OUTSIDE
Pen UP/DOWN for the “W” Command
When a command specifying the plotting of an arc is sent from the computer, this function
determines whether to raise the pen or leave it in the same status (for example, the pen remains
lowered if it was lowered when the command was received) before moving it to the starting
position for plotting.
When PEN DOWN is selected, the pen is moved to the starting position in the same status.
When PEN UP is selected, the pen is raised before moving to the starting position. These
settings are effective on cutting mode only.
Press the F3 key to select PEN UP.
Press the F4 key to select PEN DOWN.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Condition Priority
This function determines the priority of programmed cutting conditions and manual settings of
cutting conditions at the plotter’s control panel.
When MANUAL is selected, commands specifying cutting conditions from the computer are
ignored and the cutting conditions can only be set at the control panel. The registered conditions
are retained in the plotter’s internal memory even while the plotter is turned off.
When PROGRAM is selected, the cutting conditions can be set either at the plotter’s control panel
or by command input from the computer. When the plotter is turned off, however, the registered
conditions are not retained.
Press the F3 key to select MANUAL.
Press the F4 key to select PROGRAM.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.