Background Settings ♦
C5 - 5
LENGTH UNIT
METRIC\\
INCH
PEN UP MOVE
ENABLED
DISABLED\\
INITIAL BLADE
CONTROL POSITION
2mm BELOW\\
OUTSIDE
LENGTH UNIT
METRIC\\
INCH
Initial Blade Control Position (INIT. BLADE CONTROL)
This function specifies the position at which initial blade control is performed (for more information
about initial blade control see Adjusting the Blade Offset Angle.)
When 2 mm BELOW is selected, initial blade control is performed 2 mm below the starting point
of cutting.
When OUTSIDE is selected, initial blade control is performed outside of the effective cutting area.
Press the F3 key to select 2 mm BELOW.
Press the F4 key to select OUTSIDE.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Length Unit
This selection enables one to set the unit for coordinates appearing on the display panel to either
units of millimeters or inches.
Press the F3 key to select METRIC.
Press the F4 key to select INCH.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
To Next Page
Loading...
