Specifications ♦
C8 - 1
Chapter 8 Specifications
This chapter describes the plotter’s main specifications
Main Specifications: FC4100-75
CPU 16-Bit
Configuration Grit-rolling cutting plotter
Drive Digital Servo
Maximum cutting area 759 mm (29.9 in.)
Guaranteed precision cutting
area
9 m (30 ft.) with approved media
1
Compatible media width 851 mm (33.5 in.)
Maximum cutting speed 900 mm/sec with Firmware version 1.12 or before.
1260 mm/sec with Firmware version 1.13 or later.
Cutting pressure 350 g
Minimum character size 3 mm (0.125 in.) alphanumeric Helvetica med. Font
Mechanical resolution 0.005 mm (0.0002 in.)
Programmable resolution GP-GL: 0.01 mm (0.0004 in.) and HP-GL
TM 2
: 0.025 mm
(0.001in.)
Number of cutters/pens 1
Cutter types Supersteel, ceramic and sapphire blades
Pen types Water and oil based fiber-tip, water based ballpoint, ceramic,
refillable ink, and disposable ink pens
Pounce types 1.2 mm diameter pin
Compatible media Mono-vinyl chloride media, fluorescent media, and media for
illuminated displays, high reflective media
1
, up to 0.25 mm
thick, Sandblast rubber up to 1mm thick
3
Standard interfaces RS-232C, Centronics-compatible parallel
Buffer memory 1 Mb
Resident command sets
HP-GL
2
, GP-GL
LCD Panel 20 characters x 4 lines: Supports 12 languages: Danish,
Dutch, English, French, German, Hungarian, Italian,
Japanese, Norwegian, Portuguese, Spanish, Swedish
Compatible paper for pouncing Regular paper from 0.06 to 0.13 mm thick
Power supply 100-240 VAC/48-62 Hz Universal Power Supply
Power consumption 80 VA max.
Operating environment Temperature: +10 º C to +35 º C (50 º F to 95 º F)
Humidity 35 % to 75 % (non-condensing)
External dimensions 1054 mm (w) x 356 mm (h) x 465 mm (d) max.
41.5 in. (w) x 14 in. (h) x 18.3 in. (d) max.
Weight Approximately 29 kg (64 lb.) [with Accuload installed]
1 When using Graphtec-specified media
2 HP-GL is a trademark of Hewlett-Packard Company
3 Using CB15U-K30 blades to cut sandblast rubber
To Next Page
Loading...
