GRAPHTEC FC4100 series - Replacing the Cutter Blade

Cutters and Holders ♦ C2 - 4
Replacing the Cutter Blade
WARNING: Will cause injury to the Operator.
Various types of plungers are available which correspond to the diameter and type of the blade
used. Check the cutter blade you are going to use and its appropriate cutter offset value against
the table below.
Cutter pen Color
classification
Compatible
blade
types
Blade
material
Cutter
offset
values
PHP32-CB09 Blue CB09UA Supersteel
18 ± 2
PHP32-CB15 Red CB15U
CB15U-K30
Supersteel
Supersteel
28 ± 2
28 ± 2
PNP31-CB15 Red CB15-10C
CB15-05S
Ceramic
Sapphire
18 ± 2
9 ± 2
Replacing Supersteel Blades in the PHP32-CB09(N) & PHP-CB15(N)
1. Turn the plunger cap counterclockwise.
2. Remove the plunger cap.
3. Remove the blade and spring from the plunger cap.
4. Stand the cap upright.
5. Insert the new blade and spring into the hole.
6. Reattach cap to the plunger.