Setting the Interface Functions ♦ C7 - 3
STEP SIZE>
RS-232C>
COMMAND>
STEP SIZE>
RS-232C>
COMMAND>
STEP SIZE 0.100\
IN mm 0.050
0.025
0.010
STEP SIZE - Setting the Programmable Resolution
When HP-GL command mode is selected, this STEP SIZE is not displayed. When the GP-GL
command mode is selected, this function allows you to set the distance of pen movement
corresponding to the coordinate value of 1.
NOTE: Be sure to set the step size to match the step size setting of your software application
NOTE: Your step size setting is retained in the plotter’s internal memory even while the plotter is
turned off.
Press F2 key to select STEP SIZE.
Press F1 key to select 0.100.
Press F2 key to select 0.050.
Press F3 key to select 0.025.
Press F4 key to select 0.010.
Press the Enter key to register your setting and return
to the INTERFACE menu.
To Next Page
Loading...
