GRAPHTEC FC4100 series - To Change the Pounce Quality C3; To Change the Pounce Offset C3

Preparing to Cut ♦
C3 - 31
SET 17
CONDITION 3 30
4zz
POUNCE 1
SET 17
CONDITION 3 30
4
POUNCE 1zz
To Change the Pounce Quality
Press the F3 key to change QUALITY. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 8. The smaller the value,
the higher the quality.
Press the F1 key to change FORCE.
Press the F2 key to change SPEED.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Pounce Offset
Press the F4 key to change OFFSET. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 99.
Press the ENTER key to register your setting.
NOTE: For the Pounce Condition, the Cutter Offset refers to the spacing between holes in mm
units.