Background Settings ♦
C5 - 10
PEN UP MOVE
ENABLED
DISABLED\\
MEDIA SIZE SENSOR
ENABLED\\
DISABLED
LENGTH UNIT
METRIC\\
INCH
PEN UP MOVE
ENABLED
DISABLED\\
Length Unit
This selection enables one to set the unit for coordinates appearing on the display panel to either
units of millimeters or inches.
Press the F3 key to select METRIC.
Press the F4 key to select INCH.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
Pen UP Movement Control (PEN UP MOVE)
When the Plotter receives commands that specify consecutive pen movements in raised status,
the PEN UP MOVE function determines whether to move the pen to each coordinate point or to
move the pen directly to the final coordinate point.
When ENABLED is selected, the pen moves to each coordinate point in sequence.
When DISABLED is selected, the pen moves directly to the final coordinate point.
Press the F3 key to select ENABLED.
Press the F4 key to select DISABLED.
An asterisk appears beside your choice.
Press the ENTER key to register your setting and to
proceed to the next menu.
Press the NEXT key if you wish to bypass this setting
with no changes.
If you do not wish to make any changes on the background
settings, turn off the plotter.
To Next Page
Loading...
