GRAPHTEC FC4100 series - Page 125

Test Modes and Troubleshooting ♦
C6 - 15
Problem Cause Solution See section
Cut characters are
deformed.
The Step pass is too
high.
Lower the step pass
setting.
Step Pass
The starting and end
points of cutting do
not match.
Coordinate points are
incorrectly specified.
Check the coordinate
data by plotting it with
a pen.
The Offset Cut
Pressure is too low.
Raise the Offset Cut
pressure setting.
Setting the Cutting
Conditions
The media is too
flimsy.
Switch to a stronger
media.
Blade rotation is not
smooth.
Grease the cutter
blade and holder.
Replacing the Cutting
Blade
The starting and end
points of cutting thick
material do not match.
Over cutting is too
short.
Set over cut distance
correctly.
Tangential Emulation
The starting and end
points of cutting do
not match when auto
pre feed function is
used.
Pen speed is too
high, or the Quality
setting is incorrect.
Set pen condition
correctly.
Setting the Pen
Condition