Options ♦ C9 - 4
FC4100 Stand Manual
The FC4100 Stand is used to make the unit more portable, free up counter space and make storing
your plotter easier.
The Stand is option in the FC4100-75.
The Stand is standard accessory in the FC4100-100 and FC4100-130.
WARNING: Use two people to pick up the plotter.
CAUTION: Do not install the plotter onto the stand with the conveyor rollers or media installed.
The unit becomes unstable when heavy loads are added. In extreme cases, the unit
may tip over.
CAUTION: Improper assembly of these pieces may cause the unit to become unstable when
heavy loads are added. In extreme cases, the unit may tip over.
CAUTION: The longer length leg platform is installed towards the back of the unit.
NOTE: Always keep the wheels in a locked position when operating your plotter.
Contents
1. Left Side Leg
2. Right Side Leg
3. Middle Bar
4. Eight M6 x 16mm Socket Cap Screws
5. M6 Hex Key
To Next Page
Loading...
