Preparing to Cut ♦
C3 - 10
CAUTION: The position of the Middle Pinch Roller on the FC4100-100 and FC4100-130
Cutting Plotters effects the cutters performance.
n If the middle pinch roller is not positioned in the center range of the media AND located over
the grit roller, the media will not feed evenly.
CAUTION: When cutting narrow media that is 10 inches or smaller, the position of the Left
and Middle Pinch Rollers will effect the performance of the FC4100-100 and
FC4100-130 Cutting Plotters.
n Lower the media set lever to raise the pinch rollers.
n Move the left pinch roller next to the middle pinch
rollers.
n Move both the left and middle pinch rollers together
until they reach the right stop.
n Load the media so that the left side of the narrow
media under the left pinch roller.
n Adjust right pinch roller over the right side of the
media.
n Raise the media set lever to lower the pinch rollers.
Good Pinch Roller Position Poor Pinch Roller Position
Good Pinch Roller Position
To Next Page
Loading...
