Preparing to Cut ♦
C3 - 14
2. Adjust the pinch roller positions
n Position the left and right pinch
rollers to correspond with the width
of the media.
n When moving the media to the left
or right be sure to move the roll as
required to ensure that no slack
develops in the media.
n When moving the media to the left
or right be sure to move the pinch
rollers as required to hold down the
media within the appropriate range.
n Be sure to position the pinch rollers
so that they are not located right at
the edges of the media or grit
rollers.
n The FC4100-100 and FC4100-130
plotters have a middle pinch roller
that should be positioned in the
center of the media.
To Next Page
Loading...
