Preparing to Cut ♦
C3 - 17
V 1.12 GL
Buffer RAM checking
5. Hold the Media down
n Check there is no slack in the media between the roll and the front edge, reposition the
media roll if necessary.
n Turn the roll of media so that you can pull out the amount you require for your cutting
operation. (You can also use the plotter’s feed function to feed out the specified amount
of media).
n Before your start a long-length cutting operations, hand feed out the length that will be
required for the cutting operation. Let the media sit for 30 minutes to be acclimated to the
environment before starting the cutting operation. Next use the plotter’s feed function to
feed out the specified amount of media needed for your cutting operation.
6. Turn on the Power if it is off.
7. Plotter performs the initialization routine.
8. Loading of the media is complete.
To Next Page
Loading...
