Preparing to Cut ♦
C3 - 24
SET 14
CONDITION 2 30
4zz
CB09Ux 0
SET 14
CONDITION 2 30
4
CB09Ux 0zz
To Change the Cutter Quality
Press the F3 key to change QUALITY. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 8. The smaller the value,
the higher the quality.
Press the F1 key to change FORCE.
Press the F2 key to change SPEED.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Cutter Offset
Press the F4 key to change OFFSET. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from –5 to +5. For more
information, see Running Cutting Test.
Press the ENTER key to register your setting.
Fine Adjustment
1. Set the blade type to OTHER to permit fine adjustment of the CUTTER OFFSET value.
2. While referring to the figures above, gradually adjust the cutter offset value while checking the
results by running a cut test.
To Next Page
Loading...
