Advanced Functions and Settings ♦
C4 - 27
AXIS ORIGIN POINT
X= mm
Y= mm
CONDITION 2 14
30
READY 4
CB09Ux 0
DISTANCE
POINT 1-3
00399.6 mm
OK? 00400.0 mm
Press the ENTER key to store the setting.
The following menu appears.
Use the POSITION key to change the distance
value to that of the printed image the distance
between point 1 and point 3.
Press the RIGHT or LEFT ARROW key to
move the cursor.
Press the UP or DOWN key to increase or
decrease the number of distance value.
Press the ENTER key to store the setting.
The following menu appears.
The light pointer or the loupe move back to the
Axis Point 1.
If the Axis Point 1 is not the origin point of the
pre-printed image, press the POSITION key to
move the light pointer or the loupe to the
desired origin point for cutting.
If the Axis Point 1 is the origin point of the pre-
printed image, press the ENTER key.
Then press the ENTER key to store the setting.
The READY menu appears, the plotter is ready to start the
cutting operation.
To Next Page
Loading...
