RCS User Manual
16
1.- RCS Setup
At the top right of the screen, there is a gearwheel icon. When you click on it, you will access the
configuration menu.
Only system administrators and technicians have access to the RCS configuration (see section 1.3.-
System users).
The configuration menu is organized in several sheets, that will be explained bellow:
1.1.- System Configuration
This feature allows to set all the parameters of your equipment.
1.1.1.- System
In this tab you configure the network parameters, the date and the hour, the measure units, SNMP,
etc.
Device Alias: Allows to assign a name to the RCS.
Network: It is possible to set the network parameters manually or using DHCP. If you select manual
mode, you must introduce all the network parameters: IP address, DNS, etc. To save the changes
you must click on the “Apply Settings” button. To verify that your RCS is connected to the internet,
click on the button “Check Internet”.
Video IP Configuration (Option 902518): As is the case with network configuration parameters,
the parameters of the IP video input must be configured manually. So, you must introduce all the
network parameters: IP address, DNS, etc. This configuration applies to all the inputs and outputs
assigned to that port. You can also see the negotiation status, and you can select to force or select
the auto mode. To save the changes you must click on the “Apply Settings” button.
To Next Page
Loading...
Need help?
General
