RCS User Manual
63
4.3.- TS Recorder
Allows to record the transport stream of the selected channel in any of its inputs. The file will be
saved in the RCS memory.
There are two ways of operation:
1.- Instant recording: When no event recordings are configured, or when they are disabled, The
“REC” button is enabled. To start recording, press the “REC” button. To stop recording, press the
“STOP” button. While the RCS is recording, a message appears in the upper bar of the window.
2.- Event Recording (only for RCS100 and RCS400): When there are recordings configured by
alarms (see Section 1.5.1.- Alarms Profiles), The “REC” button is disabled. You can disable this
operation mode by pressing the “STOP” button (the configuration of the alarms will not be deleted).
To enable the event recording mode, press the “EVENT REC” button. When the Event Recording is
enabled, a message appears in the upper bar of the window that indicates that the RCS is recording
or waiting for the next event.
The recording duration depends on the bitrate of the transport stream and the available space in the
memory (you can store several recordings). Bellow the buttons, there is a bar graph that shows the
available recording time, depending on the bit rate and available space in memory. Next to the bar
there is a text that indicates whether the RCS is saving the recording to the internal or external disk.
To Next Page
Loading...
Need help?
General
