© Guldmann GB/US-09/2016 • #550376_3
36
SERVICE AND REPAIR
Removing bottom cover
Remove the 3 screws on both sides of the hoist.
Using a small flat screw driver, release the U shape clips
located inside the hoist, on the 4 corners of the top cover.
NOTE:
Do not force the clip to open a gentle twist of the screw
driver is enough to release the clip.
After clips have been released the cover can be removed,
If the hoist is supplied with IR control, unplug wire from
PCB before removing cover completely.
GH3
Removing covers
To Next Page
Loading...
