© Guldmann GB/US-09/2016 • #550376_3
77
SERVICE AND REPAIR
To replace the hand control, pull the emergency cord to
turn the hoist off, Remove the bottom cover.
Note: It is important to always use a anti-static mat and
wrist band when working inside the hoist.
Mark the lead so that you can replace it with the correct
length.
Disconnect the handset from the PCB.
Unclip wire from cable clips and remove wire from bottom
cover.
Being careful to guide plug through slot in casing.
Before fitting new hand control remember
to mark the cable length.
GH1
Replacing the Hand control
To Next Page
Loading...
