Guldmann GH - GH Combi Lock

1
1
1
2
2
© Guldmann GB/US-09/2016 • #550376_3
98
SERVICE AND REPAIR
GH Combi lock
Check visualy that the covers (1 & 2) do not show signs of
cracks or damage, otherwise change the damaged cover.
Check that the track part (1) is free of dust and shows no
signs of cracks or damage.
Check that the safety lock’s tongue (2) is flush with the rail
end (if not, change it).
Check that the track part (1) is free of dust and shows no
signs of cracks or damage.
Check points
• Check for corrosion (in case of corrosion, replace
safety locks)
• Check for dust at the two track parts. (if so, clean them)
• Check that the safety locks do not show signs of being
bent or damaged. (if so, replace the safety locks)
• Check that the safety locks are installed with safety
screws. (if not, do it)
• Check that the gap between the rails is 3 mm. (if not,
change it)
• Check that the safety locks’ tongues are flush with the
rail ends (if not, change it). It is important that the gap
between the rails is correct. The gap between the two
Combi lock tongues shall be 3 mm
• Check that the plastic parts do not show signs of cracks
or damage (If so, change the plastic part).