© Guldmann GB/US-09/2016 • #550376_3
81
SERVICE AND REPAIR
To replace the Charge PCB, pull the emergency cord to
turn the hoist off. Remove the bottom cover.
Note: It is important to always use a anti-static mat and
wrist band when working inside the hoist.
Disconnect the battery wires as described on page 74.
Unplug all wires from the PCB and remove from the plastic
housing.
Replace PCB and reconnect wires leaving battery wires
until last.
Note:
It is important to register all PCB exchanges on the
Guldmann traceability web site.
GH1
Replacing the charge PCB
To Next Page
Loading...
