SCP alarms
More than one SCP is in control
The SCP is simulating control and feedback
This module is in backup mode
This module is running setup
Subcodes:
0 - From SCP
The engine is in warm up mode and the operator has requested
too much throttle
The gearbox has not followed up on the operator demand or the
gear has unexpectedly changed
disagrees
Some modules are in backup mode and some are in normal. The
subcode is a bitmask of the modules that claim to be in normal.
Comparing this with what is actually in the system should show
which module disagrees. The lower four bits are the EIMs, the 4 to
7th are the JIMs, and the 8th to 15th are the SCPs. Note that
This module has no CIDs or has a invalid set of CIDs
Subcodes:
0 - OK: No error. The connected CIDs are fine
1 - Unknown: There is an unknown problem with the CID
configuration. This subcode shouldn't happen
2 - Overlap: The demands supplied by the attached CIDs
overlap. For example, more than one module may be
providing throttle demand
3 - No Space: There are more CIDs attached than the system
can manage
4 - No CIDs: No CIDs are attached
5 - Insufficient Sources: The attached CIDs do not provide
control of either steering, reverse, or throttle
6 - Expected no CIDs: The SCP is configured to be 'naked' and
expects to have no CIDs attached
7 - Incompatible CIDs: One or more of the attached CIDs are
incompatible with the system configuration. An example is a
Mouseboat on a single jet system
More than one station is set to have an autopilot
The system has not been registered or the registration is invalid
A hardware fault has occurred in this SCP.
Subcodes:
0 - Unknown
1 - Data Flash
2 - Param Flash
To Next Page
Loading...
