Jog right a third time to display the alarm sub-code.
Sub codes are described in the appendix and can be used to further diagnose the alarm's cause.
In the following example, sub-code 0 is shown.
To exit the alarm browser:
Press and hold the cancel button for 3 seconds, or
switch off power to the system.
Alarm and warning codes
This section includes a complete list of alarms and warnings.
Where the Station Control Panel (SCP) display text is separated by a forward slash / the display will alternate
between the two words.
Several alarms will cause the system to shut down and return the vessel to zero speed.
These alarms are:
BAKUP
Occurs when the system is switched into backup.
SETUP
Occurs when the system enters setup.
LOCAL
Occurs when control is taken at the local engine control panel.
DEMND/LOST
Occurs when the jet interface modules or engine interface modules lose demand from the station control
panel.
To Next Page
Loading...
