Hamilton Jet HTX30 - Configurable Parameters; Accessing Parameters Via the SCP

Appendix
HTX30 Product Manual
8-34
Configurable parameters
There are two ways to access and set configurable parameters:
1 Through the station control panel (SCP) jogstick.
2 Through the blue ARROW Support Tool.
This section describes how to access parameters via the SCP jogstick. You can also use the blue ARROW
Support Tool to access parameters (► page 5-1).
Accessing parameters via the SCP
Parameters can be accessed via the SCP when the blue ARROW control system is in setup mode.
When using setup mode, note that:
 It is not possible to enter setup mode while in backup.
 Setup mode should only be entered while the vessel is at zero speed.
 Most controls will still operate normally whilst in setup mode.
 Setup menu items are shown as text on the SCP display.
Make sure there are no active or non cancelled alarms, then enter setup mode as follows: