Hamilton Jet HTX30 - Page 4

1-ii
4 - Component Installation __________________________________________ 4-1
Tools ___________________________________________________________________ 4-1
Installation ______________________________________________________________ 4-2
Power supply _______________________________________________________ 4-2
Engine interface module _____________________________________________ 4-2
Jet interface module _________________________________________________ 4-2
Station control panel ________________________________________________ 4-2
Control input devices ________________________________________________ 4-3
Alarm sounder _____________________________________________________ 4-3
Autopilot __________________________________________________________ 4-3
Interconnecting cables _______________________________________________ 4-4
JETanchor control module ____________________________________________ 4-7
JETanchor GPS antenna ______________________________________________ 4-8
External control interface module _____________________________________ 4-11
External CAN bus terminators ________________________________________ 4-13
Internal CAN bus terminators_________________________________________ 4-14
Station control panel - after installation checks __________________________ 4-15
Power checks _____________________________________________________ 4-16
General checks ____________________________________________________ 4-16
5 - Commissioning ____________________________________________________ 5-1
Before launch setup _______________________________________________________ 5-1
The blue ARROW support tool _______________________________________________ 5-1
Overview __________________________________________________________ 5-2
Tasks _____________________________________________________________ 5-2
Start a new commissioning _________________________________________________ 5-2
Before starting _____________________________________________________ 5-3
Commissioning details _______________________________________________ 5-4
Programming the modules ____________________________________________ 5-5
Configuring the network ______________________________________________ 5-6
Module set up ______________________________________________________ 5-6
Engine interface module set up ________________________________________ 5-7
Station control panel set up ___________________________________________ 5-9
Jet interface module set up __________________________________________ 5-12
External control interface set up ______________________________________ 5-14
JETanchor control module set up ______________________________________ 5-15