Hamilton Jet HTX30 - Page 6

1-iv
Deck mounted controls ______________________________________________ 7-2
Preservation: Pre installation________________________________________________ 7-3
Service Intervals __________________________________________________________ 7-4
Servicing details __________________________________________________________ 7-4
JHPU Oil ___________________________________________________________ 7-4
Oil filter ___________________________________________________________ 7-5
Oil coolers _________________________________________________________ 7-5
Feedback sensors ___________________________________________________ 7-5
- V-belts ___________________________________________________________ 7-5
System hoses and tubing _____________________________________________ 7-7
Servicing details (electronic system) __________________________________________ 7-7
1 - Normal operation ________________________________________________ 7-7
2 - Backup operation _________________________________________________ 7-7
3 - Station control panel ______________________________________________ 7-7
4 - Jet interface module ______________________________________________ 7-7
5 - Modules general _________________________________________________ 7-8
6 - Cables and connectors ____________________________________________ 7-8
8 - Appendix ___________________________________________________________ 8-1
Conversions _____________________________________________________________ 8-2
85144 Loctite application guide _____________________________________________ 8-3
General practice ____________________________________________________ 8-3
Primers, activators and accelerators ____________________________________ 8-3
Equivalents ________________________________________________________ 8-4
85113 Tightening torques _________________________________________________ 8-13
Nut tightening torques ______________________________________________ 8-13
Screw tightening torques ____________________________________________ 8-14
Stud installation ___________________________________________________ 8-15
Set screws ________________________________________________________ 8-16
Hydraulic cylinder piston ____________________________________________ 8-16
Hydraulic fittings ___________________________________________________ 8-17
Thread lubricants __________________________________________________ 8-18
blue ARROW module dimensions ___________________________________________ 8-18
Module inputs and outputs ________________________________________________ 8-24
Module inputs and outputs __________________________________________ 8-24
Jet loom pin assignments ____________________________________________ 8-26