Operation with a roll tape dispenser (RTD)86
ORIG0140-86
4127718F/B
02/26/2007
- Other parts of the machine need no cleaning.
- Check sensors (see overview), and remove paper or blow out
dust if any.
- Switch on again.
Jam clearing
- Remove the label, pull media, close the cover, and cut excess of
paper.
Stand alone test
- Switch off the RTD.
- Disconnect the RTD from the base or switch the base off.
- Switch on the RTD.
NEVER CLEAN
THE BLACK
PRINT ROLLER
- Wait 10 seconds.
- Press the feed button until the test label output.
- Cut the test label by pulling upwards.
To Next Page
Loading...
