Operation with a roll tape dispenser (RTD) 87
ORIG0140-87
4127718F/B
02/26/2007
- To reconnect to the base:
- Switch off the RTD;
-Connect the cable to the base;
- Switch on the RTD.
Supervisor mode (see this chapter)
In case of paper type change ONLY, it is possible to adjust the
print density:
- In the main screen touch
MENU
, and select the SUPERVISOR
SETUP menu or using and key directly the
numeric key corresponding to the selection.
- To confirm, touch
OK
; the following menu is displayed:
1SECURITY
2TIME
3 TIMEOUT
5 LOAD RATE
6 DYNAMIC SCALE TESTS
7 TOUCHSCREEN CALIBR.
8 SERIAL PORT SETUP
3 TIMEOUT
SUP
DISPL...USER ...
SUP SETUP
HOME LOGOUT
OK
To Next Page
Loading...
