HIKVISION AXHub User Manual

The zone acvates all the me. It is usually used in the sites
equipped with panic buon, smoke detector and glass-break
detector.
Fire Zone
The zone acvates all the me with sound/siren output
when alarm occurs. It is usually used in
re hazardous areas
equipped with smoke detectors and temperature sensors.
Gas Zone
The zone acvates all the me with sound/siren output
when alarm occurs. It is usually used in areas equipped with
gas detectors (e.g., the kitchen).
Medical Zone
The zone
acvates all the me with beep conrmaon when
alarm occurs. It is usually used in places equipped with
medical emergency
buons.
Timeout Zone
The zone acvates all the me. The zone type is used to
monitor and report the "ACTIVE" status of a zone, but it will
only report and alarm this status
aer the programmed me
has expired. (1 to 599) Seconds. It can be used in places
equipped with magnec contacts that require access but for
only a short period (e.g.,
re hydrant box's door or another
external security box door)
Disabled Zone
Alarms will not be acvated when the zone is triggered or
tampered. It is usually used to disable faulty detectors .
5.
Enable Stay Arming Bypass, Chime, or Silent Alarm according
to your actual needs.
Note
Some zones do not support the funcon. Refer to the actual
zone to set the funcon.
6.
Enable Enroll Wireless Detector , input the serial No., and set
the linked camera No.
Note
868 Devices do not support inpung serial No.
7.
Set the Disconnecn Duraon, and the system determins
connecon fault if the disconnected duraon of the device is
longer than the congured value.
8.
Click OK.
Note
Aer seng the zone, you can enter Status → Zone to view
the zone status.
Note
Under the System Opons of the Engineer Axiom Web
plaorm there is an opon called Early Alarm, this must be
disabled for Sweden.
Output
25

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English