HIKVISION AXHub - Page 34

If you want to the link the device with a relay output to output
the alarm, set the output parameters.
Steps
1.
Click Device Management → Relay to enter the Output page.
2.
Add a wireless output module.
1) Click Wireless Output Module.
Figure 4-14 Wireless Output Module Sengs
2) Select a wireless output module number from the drop-
down list.
3) Input the serial No. of the wireless output module.
Note
The device in 868 MHZ may not support adding with serial
No..
4) Click Add.
3.
Click and the Relay Sengs window will pop up.
4.
Edit the relay name, select a link event, and set the output
delay
me duraon.
Note
If the relay has linked to the wireless output module, the
wireless output module informaon will be displayed in the
Link Wireless Output Module area.
5.
Click OK.
Note
Aer the relay is congured, you can click Status → Relay to
view the output status.
Siren
The siren is enrolled to the control panel via the wireless receiver
module, and the 868 Mhz wireless siren can be enrolled to the
hybrid control panel via the wireless receiver that is at the
address of 9.
Steps
1.
Click Device Management → Siren to enter the Siren page.
26