HIKVISION AXHub - Page 35

Figure 4-15 Siren Page
2.
Click
to enter the Siren Sengs page.
3.
Set the siren name and the volume.
Note
The available siren volume range is from 0 to 3 (funcon varies
according to the model of device) .
4.
Oponal: Enable Enroll Wireless Siren and set the siren serial
No.
Note
The siren in 868 MHZ may not support this funcon.
5.
Set the Disconnecn Duraon, and the system determins
connecon fault if the disconnected duraon of the device is
longer than the
congured value.
6.
Click OK.
Note
Aer the siren is congured, you can click Status → Siren to
view the siren status.
Keypad
You can set the parameters of the keypad that is enrolled to the
control panel.
Steps
1.
Click Device Management → Keypad to enter the page.
Figure 4-16 Keypad Page
2.
Click to enter the Keypad Sengs page.
3.
Set the keypad name.
4.
Check the check box to enable the
funcon of buzzer,
presenng card, and arming/disarming with keypad.
5.
Check the Enable check box of Back-light
O Time, and set the
duraon of light o.
6.
Select the keypad linked
paron.
27