v
────────────────────────────────────────────────────
Introduction
────────────────────────────────────────────────────
CAUTION
･
Do not insert a board other than optional interface boards into the Interface
slot. The unit software or calibration data may be lost.
･
To avoid electrocution, turn off the power to all devices before pluggingor
unplugging any of the interface connectors.
･
To avoid damaging the power cord, grasp the plug, not the cord, when
unplugging the cord from the power outlet.
･
To avoid damaging test leads, do not kink or pull on the leads.
･
Keep in mind that, in some cases, conductors to be measured may be hot.
･
Take care not to block the ventilation openings on the sides of the unit.
･
For safety reasons, only use the 9615 H.V. TEST LEAD for measurement.
･
To avoid damage to the product, protect it from vibration or shock during
transport and handling, and be especially careful to avoid dropping.
･
In the event that the equipment malfunctions in any manner during use,
turn off the power immediately, and contact your dealer or HIOKI
representative.
･
To avoid electric shock, do not exceed the lower of the ratings shown on
the instrument and test leads.
NOTE
･
Do not use the unit near any device which generates strong electromagnetic
radiation or near a static electrical charge, as these may cause errors.
･
This instrument may cause interference if used in residential areas. Such use
must be avoided unless the user takes special measures to reduce
electromagnetic emissions to prevent interference to the reception of radio and
television broadcasts.
To Next Page
Loading...
