Hioki 3158 - FAIL Mode

54
────────────────────────────────────────────────────
4.6 FAIL Mode
────────────────────────────────────────────────────
Setting procedure
0: Not set (Initial setting)
1: Set
4.6 FAIL Mode
Enable this function to restrict hold release to the
STOP
key on the main unit.
(1) Press
SHIFT
+
STOP
keys while in READY state to display the Optional
function setting screen.
(2) Use the
/ keys to move the flashing cursor to the position shown in the
figure.
(3) Use the
/ keys to set a value at the flashing cursor location.
(4) To complete the optional settings, press
SHIFT
+
STOP
keys. The unit
reverts to the READY state.